Search engine for discovering works of Art, research articles, and books related to Art and Culture
ShareThis
Javascript must be enabled to continue!

Early development of Argon-39 as a new geochronometer for geologic processes on short time scales

View through CrossRef
Up until now, the cosmogenic radioisotope 39Ar has not been used for surface exposure or burial dating of minerals due to its low concentration in rocks and the large sample size requirements for its detection by low-level counting. The novel analytical method Atom Trap Trace Analysis (ATTA) – already well established for gas samples from groundwater, ocean water or ice cores – can measure the isotopic ratio of 39Ar to stable Ar in the range of 10-16 on just a few ml STP of argon and therefore opens up new possibilities for applying 39Ar.This talk will report on the initial steps taken towards using 39Ar as a geochronometer. Calculations of production rates of 39Ar in typical continental rocks, exposed to cosmic radiation at the Earth surface, show that sample sizes of the order of 100 g of rock should yield a sufficient number of 39Ar atoms (order 103 to 104) for detection by ATTA. However, the amount of 40Ar in such samples – and therefore the total extractable Ar amount - is much lower than what is typically extracted from ice and water samples, which contain atmosphere-derived Ar. The 40Ar content in rock stems from 40K-decay and depends on the rock formation age and the potassium content. Dilution with 39Ar-free Ar results in sufficient total argon volumes for the standard ATTA analysis.Gas extractions from heated rock samples indeed show 39Ar isotope abundances 2-3 orders of magnitude above the atmospheric ratio, well within the measurement range of ATTA after dilution. In order to check the feasibility of exposure dating of rocks, several samples were taken for comparison from boulders of glacier moraines, previously dated with 10Be, in the Jamtal valley in Austria. Additionally, 10Be-dated samples from other moraine sites are to be analysed for 39Ar for further validation of 39Ar as a tool for exposure dating. As of now it remains to be seen whether reliable agreement between the dating methods can be achieved. Due to its relatively short half-life of 268 years, 39Ar would be a useful addition in multi-tracer studies on geologic processes within the last two millennia.  
Title: Early development of Argon-39 as a new geochronometer for geologic processes on short time scales
Description:
Up until now, the cosmogenic radioisotope 39Ar has not been used for surface exposure or burial dating of minerals due to its low concentration in rocks and the large sample size requirements for its detection by low-level counting.
The novel analytical method Atom Trap Trace Analysis (ATTA) – already well established for gas samples from groundwater, ocean water or ice cores – can measure the isotopic ratio of 39Ar to stable Ar in the range of 10-16 on just a few ml STP of argon and therefore opens up new possibilities for applying 39Ar.
This talk will report on the initial steps taken towards using 39Ar as a geochronometer.
Calculations of production rates of 39Ar in typical continental rocks, exposed to cosmic radiation at the Earth surface, show that sample sizes of the order of 100 g of rock should yield a sufficient number of 39Ar atoms (order 103 to 104) for detection by ATTA.
However, the amount of 40Ar in such samples – and therefore the total extractable Ar amount - is much lower than what is typically extracted from ice and water samples, which contain atmosphere-derived Ar.
The 40Ar content in rock stems from 40K-decay and depends on the rock formation age and the potassium content.
Dilution with 39Ar-free Ar results in sufficient total argon volumes for the standard ATTA analysis.
Gas extractions from heated rock samples indeed show 39Ar isotope abundances 2-3 orders of magnitude above the atmospheric ratio, well within the measurement range of ATTA after dilution.
In order to check the feasibility of exposure dating of rocks, several samples were taken for comparison from boulders of glacier moraines, previously dated with 10Be, in the Jamtal valley in Austria.
Additionally, 10Be-dated samples from other moraine sites are to be analysed for 39Ar for further validation of 39Ar as a tool for exposure dating.
As of now it remains to be seen whether reliable agreement between the dating methods can be achieved.
Due to its relatively short half-life of 268 years, 39Ar would be a useful addition in multi-tracer studies on geologic processes within the last two millennia.
 .

Related Results

Geologic Modeling And Visualization Facilitates The Transition From Exploration To Development
Geologic Modeling And Visualization Facilitates The Transition From Exploration To Development
Abstract The development of interactive modeling tools and better integration of seismic and geology allow 3D geologic modeling to play a significant, new role in...
Geology of Big Bend Ranch State Park, Texas
Geology of Big Bend Ranch State Park, Texas
Big Bend Ranch State Park, the largest in the Texas State Parks System, lies in the rugged Big Bend country of West Texas (figs. 1 and 2). The primary attraction of Big Bend countr...
DDE-TS: A semantic service for geologic time
DDE-TS: A semantic service for geologic time
Age is an important property in geologic data. It can tell us when a geologic event happened, how long did the event last. And it is important to know the sequence of events to con...
Bridging Science to Science Policy - Why it Matters with Geologic Energy Research
Bridging Science to Science Policy - Why it Matters with Geologic Energy Research
Advising policy makers of ongoing geologic energy research is a key facet of enabling long-term energy security. If policy makers and their staffs do not hear from practicing scien...
Organoprotective Properties of Argon (Review)
Organoprotective Properties of Argon (Review)
The history of studying the organoprotective properties of argon (Ar) began in 1998 when a group of Russian researchers investigated the effect of hypoxic gas mixtures on mammalian...
Interim Geologic Map of the Huntsville Quadrangle, Weber and Cache Counties, Utah
Interim Geologic Map of the Huntsville Quadrangle, Weber and Cache Counties, Utah
The Huntsville 7.5' quadrangle lies within Ogden Valley, a back valley of the Wasatch Range in Weber County, Utah, about 6 miles (10 km) east-northeast of Ogden City. Settled in 18...
Geothematic open data in Umbria region
Geothematic open data in Umbria region
Detailed information about geology, hydrogeology and seismic hazard issues for Umbria region are contained in a spatial database available as open data format (shape file or KMZ) a...

Back to Top