Search engine for discovering works of Art, research articles, and books related to Art and Culture
ShareThis
Javascript must be enabled to continue!

The Diffusion of Radionuclides through Waste Encapsulation Grouts

View through CrossRef
ABSTRACTUnited Kingdom Nirex Limited develops and advises on safe, environmentally sound and publicly acceptable options for the long-term management of radioactive waste. One option Nirex has developed is a phased geological repository concept for intermediate level waste and some low level wastes that makes use of a combination of engineered and natural barriers. Physical containment of radionuclides would be achieved by immobilisation and packaging of wastes (mostly) in stainless steel containers.Existing models of the migration of dissolved radionuclides from packaged wastes suggest that radionuclide release is determined largely by the rate of diffusion through the encapsulation grout used to immobilise the waste. The use of such models requires diffusion coefficient data for radionuclides in waste encapsulation grouts. This paper describes a programme of through-diffusion experiments, and modelling interpretation, aimed at deriving diffusion coefficients for some radionuclides in two types of encapsulation grout.An intrinsic diffusion coefficient of HTO of around 1×10−13 to 2×10−13 m2s−1 was determined for a 3:1 mix of blast furnace slag to ordinary Portland cement, compared to around 4×10−13 to 5×10−13 m2s−1 for a 3:1 mix of pulverised fuel ash to ordinary Portland cement. These values are lower than that assumed for a non-sorbing radionuclide in an earlier modelling exercise. Porosity values around 0.3 were obtained in each case. For 36Cl as chloride, the experiments showed no significant breakthrough over the experimental timescale of about one year, suggesting an intrinsic diffusion coefficient below 5×10−13 m2s−1. One possibility is that chlorine-containing solids are precipitating in the cement. An intrinsic diffusion coefficient for 137Cs in the 3:1 mix of pulverised fuel ash to ordinary Portland cement of 4×10−15 m2s−1 was estimated, significantly lower than that determined for HTO.The results from three of the sixteen experiments could not be fitted with a simple diffusion model, and for a further five experiments there was some doubt as to whether simple diffusion behaviour had been observed. It is suggested that this may have been due to cracks in the grouts that were sufficiently large to affect the diffusion properties of the grouts, although none was visible to the naked eye. Cracking of the waste encapsulation grouts could provide a mechanism for enhanced migration of radionuclides from waste packages, compared with diffusion in a homogeneous porous medium alone.
Title: The Diffusion of Radionuclides through Waste Encapsulation Grouts
Description:
ABSTRACTUnited Kingdom Nirex Limited develops and advises on safe, environmentally sound and publicly acceptable options for the long-term management of radioactive waste.
One option Nirex has developed is a phased geological repository concept for intermediate level waste and some low level wastes that makes use of a combination of engineered and natural barriers.
Physical containment of radionuclides would be achieved by immobilisation and packaging of wastes (mostly) in stainless steel containers.
Existing models of the migration of dissolved radionuclides from packaged wastes suggest that radionuclide release is determined largely by the rate of diffusion through the encapsulation grout used to immobilise the waste.
The use of such models requires diffusion coefficient data for radionuclides in waste encapsulation grouts.
This paper describes a programme of through-diffusion experiments, and modelling interpretation, aimed at deriving diffusion coefficients for some radionuclides in two types of encapsulation grout.
An intrinsic diffusion coefficient of HTO of around 1×10−13 to 2×10−13 m2s−1 was determined for a 3:1 mix of blast furnace slag to ordinary Portland cement, compared to around 4×10−13 to 5×10−13 m2s−1 for a 3:1 mix of pulverised fuel ash to ordinary Portland cement.
These values are lower than that assumed for a non-sorbing radionuclide in an earlier modelling exercise.
Porosity values around 0.
3 were obtained in each case.
For 36Cl as chloride, the experiments showed no significant breakthrough over the experimental timescale of about one year, suggesting an intrinsic diffusion coefficient below 5×10−13 m2s−1.
One possibility is that chlorine-containing solids are precipitating in the cement.
An intrinsic diffusion coefficient for 137Cs in the 3:1 mix of pulverised fuel ash to ordinary Portland cement of 4×10−15 m2s−1 was estimated, significantly lower than that determined for HTO.
The results from three of the sixteen experiments could not be fitted with a simple diffusion model, and for a further five experiments there was some doubt as to whether simple diffusion behaviour had been observed.
It is suggested that this may have been due to cracks in the grouts that were sufficiently large to affect the diffusion properties of the grouts, although none was visible to the naked eye.
Cracking of the waste encapsulation grouts could provide a mechanism for enhanced migration of radionuclides from waste packages, compared with diffusion in a homogeneous porous medium alone.

Related Results

PENGETAHUAN MAHASISWA TATA BUSANA TENTANG ZERO WASTE PATTERN
PENGETAHUAN MAHASISWA TATA BUSANA TENTANG ZERO WASTE PATTERN
Textile waste is one of the 2nd largest types of waste in the world. The increasing amount of textile waste will have an impact on the environment. There has not been much developm...
DENGUE OUTBREAK -IS THE PANIC JUSTIFIED ?
DENGUE OUTBREAK -IS THE PANIC JUSTIFIED ?
In this era of startling developments in the medical field there remains a serious worry about the  hazardous  potential  of  various  by  products  which  if  not  properly  addre...
Investigation of the adherence between clay blocks and grouts
Investigation of the adherence between clay blocks and grouts
Abstract This study aims to evaluate the adherence between clay blocks and grouts. For this purpose, push-out and pull-out tests were performed to assess the adherence presented by...
STRENGTH DEVELOPMENT OF EPOXY GROUTS FOR PIPELINE REHABILITATION
STRENGTH DEVELOPMENT OF EPOXY GROUTS FOR PIPELINE REHABILITATION
Polymeric composites are increasingly being used as infill material in civil engineering applications for repairing damaged structures, including corroded pipelines. In repairing d...
EVALUASI SISTEM PENGENDALIAN MANAJEMEN PADA PELAYANAN PERSAMPAHAN PEMERINTAH KABUPATEN TEMANGGUNG
EVALUASI SISTEM PENGENDALIAN MANAJEMEN PADA PELAYANAN PERSAMPAHAN PEMERINTAH KABUPATEN TEMANGGUNG
Garbage is a problem that is still homework for most areas, starting from the household scale, village/kelurahan, district, and even national scale. A management control system in ...
Cementitious Grouts Containing Irradiated Waste Polyethylene Terephthalate
Cementitious Grouts Containing Irradiated Waste Polyethylene Terephthalate
This chapter describes a review of the design and formulation of various cementitious grouts for semi-flexible pavement surfaces. Additionally, the authors also conducted extensive...
Studi Timbulan dan Komposisi Sampah Kampus 3 Universitas AKPRIND Indonesia
Studi Timbulan dan Komposisi Sampah Kampus 3 Universitas AKPRIND Indonesia
Waste management is a critical issue faced by many institutions, including universities. AKPRIND University Indonesia, as an educational institution, has a large population, includ...

Back to Top