Test of Inclined Double Beads on Aluminum Sheets

<div class="section abstract"><div class="htmlview paragraph">Draw beads are widely used in the binder of a draw die for regulating the restraining force and control the draw-in of a metal blank. Different sheet materials and local panel geometry request different local draw bead configurations. Even the majority of draw bead is single draw bead, the alternative double draw bead does have its advantages, such as less bending damage may be brought to the sheet material and more bead geometry features available to work on. In this paper, to measure the pulling force when a piece of sheet metal passing through a draw bead on an inclined binder, the AA5XXX and AA6XXX materials were tested and its strain were measured with a digital image correlation (DIC) system. Five different types of double bead configurations were tested. The beads are installed in a Stretch-Bend-Draw-System (SBDS) test device. The clearance between a male and a female bead is 10% thicker than the sheet material. A tensile machine was used to record the pulling force. The comparison of pulling force and strain are reported in this paper. These experiment results can be used to validate the results of FEA simulation. It was found that the pulling force of a double bead is more sensitive than the single bead. Details of the sensitivity were illustrated and discussed in the paper.</div></div>