Javascript must be enabled to continue!
Analysis of the Profitability of Heating a Retrofitted Building with an Air Heat Pump in Polish Climatic Conditions
View through CrossRef
The transformation of energy systems towards low emission is one of the key assumptions of the climate and energy policy of the European Union and many countries around the world. These changes include not only the power and transport sectors but also the heating of residential buildings, which consume significant amounts of energy and emit large amounts of greenhouse gases. This article presents a detailed comparative analysis of the costs of heating using an air-to-water heat pump and a condensing gas boiler. The study concerned a retrofitted single-family building from the 1990s, located in southern Poland. The calculations were made taking into account daily meteorological data for two full heating seasons: 2022/2023 and 2023/2024. This approach made it possible to more precisely reproduce real operating conditions. The study was conducted for various configurations of the central heating system: surface and radiator. The following parameters were also taken into account: (1) variable heat pump parameters, such as supply temperature LWT and coefficient of performance COP; (2) current tariffs for electricity and natural gas; and (3) forecasted tariffs for electricity and natural gas in the conditions of market liberalization and phasing out of protective mechanisms. A comparison of the two heating seasons revealed lower costs with a heat pump. In some cases, the cost of heat generated by a gas boiler was over 100% higher than with a heat pump. This applies to both heating seasons. Under the current tariffs, the calculated gas cost for the first season was PLN 6856 (EUR 1605) (1 EUR = 4.27 PLN) compared to heat pump heating costs ranging from PLN 3191 to PLN 4576 (EUR 747 to 1072). For future gas and electricity tariffs, the costs were PLN 8227 (EUR 1926) for gas and PLN 3841 to PLN 5304 (EUR 899 to 1242) for a heat pump. Similarly, for the second heating season, these values were PLN 6055 (EUR 1418) for gas heating and PLN 2741–3917 (EUR 642–917) for a heat pump under the current tariffs, and PLN 7267 (EUR 1702) and PLN 3307–4540 (EUR 774–1064) under future tariffs. This means percentage savings of between approximately 33% and 55%, depending on the heating type and tariff. Therefore, the obtained results indicate the higher profitability of using an air heat pump compared to a gas boiler. This advantage was maintained in all the discussed scenarios, and its scale depended on the type of installation, supply temperature, and the selected electricity tariff. The highest economic profitability was noted for low-temperature systems. These results can provide a basis for making rational investment and design decisions in the context of the energy transformation of single-family housing.
Title: Analysis of the Profitability of Heating a Retrofitted Building with an Air Heat Pump in Polish Climatic Conditions
Description:
The transformation of energy systems towards low emission is one of the key assumptions of the climate and energy policy of the European Union and many countries around the world.
These changes include not only the power and transport sectors but also the heating of residential buildings, which consume significant amounts of energy and emit large amounts of greenhouse gases.
This article presents a detailed comparative analysis of the costs of heating using an air-to-water heat pump and a condensing gas boiler.
The study concerned a retrofitted single-family building from the 1990s, located in southern Poland.
The calculations were made taking into account daily meteorological data for two full heating seasons: 2022/2023 and 2023/2024.
This approach made it possible to more precisely reproduce real operating conditions.
The study was conducted for various configurations of the central heating system: surface and radiator.
The following parameters were also taken into account: (1) variable heat pump parameters, such as supply temperature LWT and coefficient of performance COP; (2) current tariffs for electricity and natural gas; and (3) forecasted tariffs for electricity and natural gas in the conditions of market liberalization and phasing out of protective mechanisms.
A comparison of the two heating seasons revealed lower costs with a heat pump.
In some cases, the cost of heat generated by a gas boiler was over 100% higher than with a heat pump.
This applies to both heating seasons.
Under the current tariffs, the calculated gas cost for the first season was PLN 6856 (EUR 1605) (1 EUR = 4.
27 PLN) compared to heat pump heating costs ranging from PLN 3191 to PLN 4576 (EUR 747 to 1072).
For future gas and electricity tariffs, the costs were PLN 8227 (EUR 1926) for gas and PLN 3841 to PLN 5304 (EUR 899 to 1242) for a heat pump.
Similarly, for the second heating season, these values were PLN 6055 (EUR 1418) for gas heating and PLN 2741–3917 (EUR 642–917) for a heat pump under the current tariffs, and PLN 7267 (EUR 1702) and PLN 3307–4540 (EUR 774–1064) under future tariffs.
This means percentage savings of between approximately 33% and 55%, depending on the heating type and tariff.
Therefore, the obtained results indicate the higher profitability of using an air heat pump compared to a gas boiler.
This advantage was maintained in all the discussed scenarios, and its scale depended on the type of installation, supply temperature, and the selected electricity tariff.
The highest economic profitability was noted for low-temperature systems.
These results can provide a basis for making rational investment and design decisions in the context of the energy transformation of single-family housing.
Related Results
Optimisation of Heating System Powered by Air Heat Pump and Gas Condensing Boiler Hybrid Unit
Optimisation of Heating System Powered by Air Heat Pump and Gas Condensing Boiler Hybrid Unit
Gas condensing boiler and air to water heat pump hybrid unit is an optimal way to introduce renewable energy resources in existing buildings. Two energy sources (gas & electric...
Effects of the operation parameters of a closed-type heating tower on the performance of heating tower heat pump system
Effects of the operation parameters of a closed-type heating tower on the performance of heating tower heat pump system
The ventilator of the heating tower and the circulating pump of the anti-freeze solution are the main electrical equipment of a heating tower heat pump system, besides the compress...
Air Heat Pump in Wind Power
Air Heat Pump in Wind Power
An experimental facility has been developed and manufactured to study the disruptive flow in an air heat pump. The propeller of the heat pump does not produce pulling or pushing fo...
British Food Journal Volume 44 Issue 12 1942
British Food Journal Volume 44 Issue 12 1942
Heat also facilitates the transmission of water through the cell walls, thereby assisting its passage from the interior to the surface of the material; it increases the vapour pres...
Architecture and adaptation
Architecture and adaptation
«The architectural work transcends the architect, goes beyond the moment in which its construction takes place, and therefore can be contemplated under the changing lights of histo...
Decarbonising Residential Heating: A Systematic Review of Life Cycle Impacts for Residential and District Heat Pump Systems
Decarbonising Residential Heating: A Systematic Review of Life Cycle Impacts for Residential and District Heat Pump Systems
Electrification of residential heating via heat pumps is a key aspect of the global strategy to reach Net Zero. This is because heat pumps which can convert electricity directly to...
Downhole Beam Pump Operation: Slippage and Buckling Forces Transmitted to the Rod String
Downhole Beam Pump Operation: Slippage and Buckling Forces Transmitted to the Rod String
Abstract
New results for downhole beam or rod pumps, from fairly recent test data are in conflict with traditional relationships. Additional testing is in progres...
Downhole Beam Pump Operation: Slippage and Buckling Forces Transmitted to the Rod String
Downhole Beam Pump Operation: Slippage and Buckling Forces Transmitted to the Rod String
Abstract
New results for downhole beam or rod pumps from fairly recent test data are in conflict with traditional relationships. Additional testing is in progress...

