Experimental Study of Ultrasonic Vibration Effects on Punch Radial in Sheet Hydroforming Process

Abstract Nowadays, one of the metal forming processes that are widely used in industries is sheet hydroforming. Because of high complexity and sensitivity, this process needs precise calculations in the die and method to control metal flow correctly and prevent defects. Therefore recently, new processes were combined to this process to increase precision and effectiveness. For example, ultrasonic vibration assistance forming. Using hydroforming and ultrasonic vibration as new methods were studied in several research types separately, and each of them redounded to different analyses and improvements in the process. Even synchronic use of these two methods was studied in some metal forming processes such as tube hydroforming, but it has not been studied in sheet hydroforming. Therefore the aim of this research is the experimental study of St14 sheet hydroforming ultrasonic vibration assistance. For this purpose, ultrasonic vibration (with 20 KHz frequency and 4μm amplitude) was applied to a hydromechanical deep drawing die into punch radial in the hydroforming process. Then process parameters consisting of LDR, maximum height, forming force, safe working zone, and thickness distribution were determined and compared in four case states conventional deep drawing(CDD), hydroforming deep drawing(HDD), ultrasonic vibration assistance deep drawing(UDD) and ultrasonic vibration assistance hydroforming deep drawing(UHDD). Results indicated that applying ultrasonic vibration into the sheet hydroforming process increases LDR and the maximum height of the cup, decreases forming force and develops a safe working zone. Also was very effective in thickness distribution and decrease of sheet thinning in critical sections.