Javascript must be enabled to continue!
Quantifying CO2 Dissolution and Mineralisation Using Inherent Isotope Ratios at the CarbFix2 Project, Iceland
View through CrossRef
Injection of CO2 into reactive rocks for permanent fixation into new minerals guarantees storage security1. The leading demonstration of this technology is the CarbFix2 project, in SW Iceland, which captures CO2 and H2S gases emitted from the Hellisheiði geothermal field via dissolution into water and then injects this mix into the subsurface. The captured CO2 and H2S then reacts to form stable minerals within the basaltic rocks2.Traditional verification of subsurface CO2 sequestration has predominantly relied on artificial or indirect geochemical tracers. Here, we demonstrate the use of inherent isotopic ratios of noble gases and stable isotopes of C, D and O within CO2 and H2O samples obtained from the CarbFix2 project, in order to monitor and quantify surface CO2 capture via dissolution and subsequent subsurface mineralisation.Initially, shifts in the inlet and outlet CO2/3He and C isotope ratios (δ13C) from the Carbfix2 CO2 capture tower are used to determine that 50% (±4%) of the CO2 was removed from the inlet gas stream via dissolution in the water wash. This estimate of the portion of CO2 captured correlates with independent measurements from existing methods used by CarbFix.It is then calculated that the dissolved CO2 has a CO2/3He of 9.6 x 109 (± 8.9 x 108) and a δ13CCO2 isotope ratio of -5.0‰ (± 0.2‰) V-PDB. Comparison of these values to those measured in CarbFix2 monitoring wells shows that lower CO2/3He and higher δ13CCO2 than expected are observed in the monitoring wells, compared with a baseline scenario where no mineralisation occurs. This indicates that a significant portion of CO2 has been removed from the injected fluids.Through integration of these findings with monitoring well data, mineralisation and mixing dynamics at a reservoir temperature of 265°C were explored. A critical role for oxygen isotope ratios of water (δ18O) in distinguishing remaining injectate from background reservoir CO2 was identified, which aids in the interpretation of the CO2/3He and δ13C data.The results align with previously documented estimates of the proportion of CO2 mineralised obtained from other independent methods2,3. However, further sample collection and analysis is required to affirm these promising initial mineralisation estimates acquired from inherent tracers.References1Snæbjörnsdóttir et al., 2020, Nature Reviews Earth & Env. 1, 90–102. DOI:10.1038/s43017-019-0011-82Clark et al., 2020, GCA, 279, 45-66, DOI:10.1016/j.gca.2020.03.0393Ratouis et al., 2022, IJGGC, 114, 103586, DOI:10.1016/j.ijggc.2022.10358
Title: Quantifying CO2 Dissolution and Mineralisation Using Inherent Isotope Ratios at the CarbFix2 Project, Iceland
Description:
Injection of CO2 into reactive rocks for permanent fixation into new minerals guarantees storage security1.
The leading demonstration of this technology is the CarbFix2 project, in SW Iceland, which captures CO2 and H2S gases emitted from the Hellisheiði geothermal field via dissolution into water and then injects this mix into the subsurface.
The captured CO2 and H2S then reacts to form stable minerals within the basaltic rocks2.
Traditional verification of subsurface CO2 sequestration has predominantly relied on artificial or indirect geochemical tracers.
Here, we demonstrate the use of inherent isotopic ratios of noble gases and stable isotopes of C, D and O within CO2 and H2O samples obtained from the CarbFix2 project, in order to monitor and quantify surface CO2 capture via dissolution and subsequent subsurface mineralisation.
Initially, shifts in the inlet and outlet CO2/3He and C isotope ratios (δ13C) from the Carbfix2 CO2 capture tower are used to determine that 50% (±4%) of the CO2 was removed from the inlet gas stream via dissolution in the water wash.
This estimate of the portion of CO2 captured correlates with independent measurements from existing methods used by CarbFix.
It is then calculated that the dissolved CO2 has a CO2/3He of 9.
6 x 109 (± 8.
9 x 108) and a δ13CCO2 isotope ratio of -5.
0‰ (± 0.
2‰) V-PDB.
Comparison of these values to those measured in CarbFix2 monitoring wells shows that lower CO2/3He and higher δ13CCO2 than expected are observed in the monitoring wells, compared with a baseline scenario where no mineralisation occurs.
This indicates that a significant portion of CO2 has been removed from the injected fluids.
Through integration of these findings with monitoring well data, mineralisation and mixing dynamics at a reservoir temperature of 265°C were explored.
A critical role for oxygen isotope ratios of water (δ18O) in distinguishing remaining injectate from background reservoir CO2 was identified, which aids in the interpretation of the CO2/3He and δ13C data.
The results align with previously documented estimates of the proportion of CO2 mineralised obtained from other independent methods2,3.
However, further sample collection and analysis is required to affirm these promising initial mineralisation estimates acquired from inherent tracers.
References1Snæbjörnsdóttir et al.
, 2020, Nature Reviews Earth & Env.
1, 90–102.
DOI:10.
1038/s43017-019-0011-82Clark et al.
, 2020, GCA, 279, 45-66, DOI:10.
1016/j.
gca.
2020.
03.
0393Ratouis et al.
, 2022, IJGGC, 114, 103586, DOI:10.
1016/j.
ijggc.
2022.
10358.
Related Results
Hydromechanical impact of carbon mineralisation in basalts
Hydromechanical impact of carbon mineralisation in basalts
Permanent CO2 storage in basalts by means of mineralisation is a promising cost-effective way to achieving reduction of carbon emissions in view of climate change mitigation. CO2 i...
Rapid Large-scale Trapping of CO2 via Dissolution in US Natural CO2 Reservoirs
Rapid Large-scale Trapping of CO2 via Dissolution in US Natural CO2 Reservoirs
Naturally occurring CO2 reservoirs across the USA are critical natural analogues of long-term CO2 storage in the subsurface over geological timescales and provide valuable insights...
Design And Operation Of The Levelland Unit CO2 Injection Facility
Design And Operation Of The Levelland Unit CO2 Injection Facility
Abstract
The Levelland CO2 Facility provides CO2 storageand handling capacity for the five CO2 injection pilots located in the Levelland Unit. Facilities pilots l...
Resolving the Hf-Nd paradox of early Earth crust-mantle evolution
Resolving the Hf-Nd paradox of early Earth crust-mantle evolution
<p>One of the fundamental tenets of geochemistry is that the Earth&#8217;s crust has been extracted from the mantle creating a crustal reservoir enriched&...
A Novel Approach to Accelerate CO2 Mineralization Storage through CO2 Nanobubbles
A Novel Approach to Accelerate CO2 Mineralization Storage through CO2 Nanobubbles
Abstract
Carbon capture and storage (CCS) technology is a crucial means to address global climate change and reduce atmospheric CO2. CO2 mineralization storage can s...
Aquifer Management to Accelerate CO2 Dissolution and Trapping
Aquifer Management to Accelerate CO2 Dissolution and Trapping
Abstract
Bulk phase CO2 injection can provide substantive reduction in CO2 emissions only if additional brine is produced out of the system to address relevant risk ...
Preliminary Assessment of CO2 Storage Potential in the H-59 Block in Jilin Oilfield CCS Project
Preliminary Assessment of CO2 Storage Potential in the H-59 Block in Jilin Oilfield CCS Project
The block H-59 in the Daqingzijing region was selected as a pilot site for the first stage of the CCS project in Jilin oilfield after an extensive assessment. This block is a light...
Impact of CCUS Impurities on Dense Phase CO2 Pipeline Surface Engineering Design
Impact of CCUS Impurities on Dense Phase CO2 Pipeline Surface Engineering Design
Abstract
Numerous CO2 injection pipeline applications have been developed and implemented in the past decades in the UAE and all around the globe. Transporting the C...

