Javascript must be enabled to continue!
Field Experiments of Hyporheic Flow Affected by a Clay Lens
View through CrossRef
As a typical water exchange of surface water and groundwater, hyporheic flow widely exists in streambeds and is significantly affected by the characteristics of sediment and surface water. In this study, a low-permeability clay lens was chosen to investigate the influence of the streambed heterogeneity on the hyporheic flow at a river section of the Xin’an River in Anhui Province, China. A 2D sand tank was constructed to simulate the natural streambed including a clay lens under different velocity of surface water velocity. Heat tracing was used in this study. In particular, six analytical solutions based on the amplitude ratio and phase shift of temperatures were applied to calculate the vertical hyporheic flux. The results of the six methods ranged from −102.4 to 137.5 m/day and showed significant spatial differences. In view of the robustness of the calculations and the rationality of the results, the amplitude ratio method was much better than the phase shift method. The existence of the clay lens had a significant influence on the hyporheic flow. Results shows that the vertical hyporheic flux in the model containing a clay lens was lower than that for the blank control, and the discrepancy of the hyporheic flow field on both sides of the lens was obvious. Several abnormal flow velocity zones appeared around the clay lens where the local hyporheic flow was suppressed or generally enhanced. The hyporheic flow fields at three test points had mild changes when the lens was placed in a shallow layer of the model, indicating that the surface water velocity only affect the hyporheic flow slightly. With the increasing depth of the clay lens, the patterns of the hyporheic flow fields at all test points were very close to those of the hyporheic flow field without a clay lens, indicating that the influence of surface water velocity on hyporheic flow appeared gradually. A probable maximum depth of the clay lens was 30 to 40 cm, which approached the bottom of the model and a clay lens buried lower than this maximum would not affect the hyporheic flow any more. Influenced by the clay lens, hyporheic flow was hindered or enhanced in different regions of streambed, which was also depended on the depth of lens and surface water velocity. Introducing a two-dimensional sand tank model in a field test is an attempt to simulate a natural streambed and may positively influence research on hyporheic flow.
Title: Field Experiments of Hyporheic Flow Affected by a Clay Lens
Description:
As a typical water exchange of surface water and groundwater, hyporheic flow widely exists in streambeds and is significantly affected by the characteristics of sediment and surface water.
In this study, a low-permeability clay lens was chosen to investigate the influence of the streambed heterogeneity on the hyporheic flow at a river section of the Xin’an River in Anhui Province, China.
A 2D sand tank was constructed to simulate the natural streambed including a clay lens under different velocity of surface water velocity.
Heat tracing was used in this study.
In particular, six analytical solutions based on the amplitude ratio and phase shift of temperatures were applied to calculate the vertical hyporheic flux.
The results of the six methods ranged from −102.
4 to 137.
5 m/day and showed significant spatial differences.
In view of the robustness of the calculations and the rationality of the results, the amplitude ratio method was much better than the phase shift method.
The existence of the clay lens had a significant influence on the hyporheic flow.
Results shows that the vertical hyporheic flux in the model containing a clay lens was lower than that for the blank control, and the discrepancy of the hyporheic flow field on both sides of the lens was obvious.
Several abnormal flow velocity zones appeared around the clay lens where the local hyporheic flow was suppressed or generally enhanced.
The hyporheic flow fields at three test points had mild changes when the lens was placed in a shallow layer of the model, indicating that the surface water velocity only affect the hyporheic flow slightly.
With the increasing depth of the clay lens, the patterns of the hyporheic flow fields at all test points were very close to those of the hyporheic flow field without a clay lens, indicating that the influence of surface water velocity on hyporheic flow appeared gradually.
A probable maximum depth of the clay lens was 30 to 40 cm, which approached the bottom of the model and a clay lens buried lower than this maximum would not affect the hyporheic flow any more.
Influenced by the clay lens, hyporheic flow was hindered or enhanced in different regions of streambed, which was also depended on the depth of lens and surface water velocity.
Introducing a two-dimensional sand tank model in a field test is an attempt to simulate a natural streambed and may positively influence research on hyporheic flow.
Related Results
Influence of hyporheic zone characteristics on the structure and activity of microbial assemblages
Influence of hyporheic zone characteristics on the structure and activity of microbial assemblages
Summary
The hyporheic zone is a pivotal environment for biogeochemical processes in riverine ecosystems. However, the responses of hyporheic microbial assemblage structure and ac...
Study on the Migration of Manganese in the Hyporheic Zone of a Reservoir
Study on the Migration of Manganese in the Hyporheic Zone of a Reservoir
Abstract
In order to study the laws of the spatial change of manganese in hyporheic zone, this paper takes Reservoir A as the actual research object, and analyzes th...
Influence of streambed sediment clogging on microbial processes in the hyporheic zone
Influence of streambed sediment clogging on microbial processes in the hyporheic zone
Summary1. The hyporheic zone plays a key role in hydrological exchange and biogeochemical processes in streambed sediments. The clogging of sediments caused by the deposition of pa...
Multiphase Flow Metering:An Evaluation of Discharge Coefficients
Multiphase Flow Metering:An Evaluation of Discharge Coefficients
Abstract
The orifice discharge coefficient (CD) is the constant required to correct theoretical flow rate to actual flow rate. It is known that single phase orifi...
Pressure Analysis of DST Flow Period Or Slug Flow For Horizontal Wells In Homogeneous Reservoir
Pressure Analysis of DST Flow Period Or Slug Flow For Horizontal Wells In Homogeneous Reservoir
Abstract
By the transient pressure for horizontal well with constant flow rate and Duhamel's principle, this paper presents the method to calculate the transient ...
Determinants of Cerebrovascular Reserve in Patients with Significant Carotid Stenosis
Determinants of Cerebrovascular Reserve in Patients with Significant Carotid Stenosis
AbstractIntroductionIn patients with 70% to 99% diameter carotid artery stenosis cerebral blood flow reserve may be protective of future ischemic cerebral events. Reserve cerebral ...
Experimental and Numerical Analysis of the Flow Field in the Integrated Valve for the Control Rod Hydraulic Drive System
Experimental and Numerical Analysis of the Flow Field in the Integrated Valve for the Control Rod Hydraulic Drive System
Control Rod Hydraulic Drive System (CRHDS) is a new type of built-in control rod drive technology, and the Integrated Valve (IV) is the key control component of it. The pulse water...
Clay Typing from Downhole Array Electromagnetic Measurements
Clay Typing from Downhole Array Electromagnetic Measurements
The amount and type of clays in reservoirs have a significant impact on formation evaluation and reservoir performance studies. Currently, clay typing requires either reservoir cor...

