Synthesis and experimental studies of the method of manufacturing screw spirals with a rotating plug with feasibility study

The structural synthesis of methods of winding screw spirals using the method of hierarchical grouping by means of morphological analysis is carried out and a number of alternatives that allowed to create the improved way of winding screw spirals with rotating plug is obtained. On the basis of the conducted multifactor experiment the study of torque of the process of screw workpiece calibration per step was performed and the regression dependence was obtained to determine the influence of winding width, wedge angle and winding thickness on the torque of the calibration process. It is established that calibration process of the turn of screw workpiece per step depends on the width, thickness of the spiral and the angle of the wedge of the device. With increasing inclination of the wedge of the device and the thickness of the winding, for the material steel 08kp, the torque increases and reaches 79 N m. It is established that the dominant factor influencing the value of torque is the angle of the wedge of the device, and the least influential is the winding width. The technical and economic estimation of the method of winding screw spirals with rotating plug is carried out and found that the annual economic effect, when replacing the basic version of winding screw spirals (winding on the frame) on the design (winding with rotating plug), when operating equipment in one shift is 16995.79 UAH.