Development of transposon-mediated gene delivery systems with improved safety for the use in gene and cell therapy

Chapter I of this work addressed the piggyBac (PB) transposon system, a non-viral genome engineering tool that is capable of efficiently performing stable integration of DNA sequences into a target cells genome and has already been used in clinical trials. However, the PB transposase has the problematic property of preferentially integrating transposons near transcriptional start sites (TSSs). This increases the likelihood of causing genotoxic effects, limiting its potential use as a tool in clinical applications. It has been shown in the past that the PB transposase shows physical interactions with BET proteins (e.g. BRD4) through Co-IP experiments. Representatives of these proteins are part of the transcriptional activation complex and are abundant at TSSs. Accordingly, it was previously proposed that this interaction is the underlying cause for the biased integration preference. For the first chapter of this thesis, the goal was to disrupt this interaction potentially modifying said integration preference. A secondary structure hypothesized to be mainly responsible for said interaction was extensively mutated resulting in several PB variants that were analyzed for their interaction capacity through a series of Co-IP experiments with BRD4. In total, seven substitutions were identified (E380F, V390K, T392Y, M394R, K407C, K407Q, and K407V) which exhibited reduced interaction capacity with BRD4. Each of the aforementioned mutants were used to generate integration libraries and, through NGS, it was determined if the integration preferences of the respective mutants had changed. In the immediate range 200 base pairs up- and downstream from known TSSs all mutants used exhibited a reduced integration bias. At a wider observation window 3 kbp up- and downstream from TSSs, further mutants with the substitutions M394R, T392Y and V390K showed a reduction in integration frequency of 17.3%, 1.5% and 5.4%, respectively, compared to the wildtype. Of particular note was the M394R mutant, which showed a reduction in all window sizes analyzed with a maximum of 65% less integration preference in the immediate vicinity of TSSs, theoretically generating a safety advantage over the wildtype transposase. Chapter II was dedicated to the overall safety improvement for transposon-based gene modification and addresses the time point after the transgene has already been integrated and serious side effects may not be preventable. With this in mind, the aim was to develop a novel suicide-switch that can be stably introduced into cells via transposition, and reliably leads to cell death of the modified cells once activated. A system based on CRISPR/Cas9 was developed, where single guide RNAs were used to guide the Cas9 nuclease to Alu elements. These are short, repetitive sequences, which are distributed over the human genome in more than one million copies. Inducing double strand breaks within these elements would lead to genomic fragmentation and cell death. To be inducible, a transcriptional as well as post- translational control mechanism was added. Transcription of the Cas9 nuclease was regulated using a tet-on system, making expression dependent on doxycycline (DOX) supplementation. Furthermore, a version of the Cas9 nuclease called arC9 was used that allows double strand break generation only in the presence of 4-Hydroxytamoxifen (4-HT). Together with an expression cassette for the Alu-specific guide RNA and an expression cassette for the reverse tetracycline controlled transactivator all components were arranged between transposase-specific recognition sequences on a plasmid to allow transposon-system based gene transfer. The system was tested in HeLa cells. First, conditional expression of the arC9 nuclease was confirmed by addition of 1 μg/ml DOX. Second, the suicide-switch was further induced by adding 200 nM 4-HT and protein extracts were assayed for the KAP1 phosphorylation. Only upon induction with DOX and 4-HT phosphorylated KAP1 was detected, indicating DNA damage. Further, extensive growth and survival experiments were conducted to determine the effect of suicide-switch induction on cell proliferation and survival. Between 24 and 48 hours after induction, a halt in cell division was detected, after which extensive cell death was observed. Within 5 days post induction, >99% of all cells were eliminated. In the absence of both inducers, no significant differences in survival were observed compared to control cells line lacking Alu-specific guide RNAs. Microscopic examinations of the <1% surviving cell fraction revealed a senescence-associated phenotype and showed no signs of resumption of the cell division process. Accordingly, the second chapter of this thesis also achieved its goal in developing a functional suicide-switch that can be inserted into human cells via transposition, is highly dependent on the necessary induction signals, and exhibits excellent elimination capabilities in the context tested.