Endurance and Aerodynamic Performance Certification of Aircraft De/Anti-icing Fluids

<div class="htmlview paragraph">Three performance certification tests are required for the assessment of aircraft de/anti-icing fluids. The two first, measuring anti-icing endurance, consists of the Water Spray (WSET) and the High Humidity Endurance Tests (HHET). The third, for aerodynamic performance, consists of the Flat Plate Elimination Test (FPET). The three performance tests, used for both deicing and anti-icing fluids, are described in the annexes of AMS1424 and AMS1428. Since February, 2003 they are covered by aerospace standards AS5900 for aerodynamic, and AS5901 for anti-icing endurance performance. The WSET anti-icing endurance test measures the time that a fluid protects a plate, inclined at a 10° angle, subjected to freezing precipitation, from a specified amount of icing. This WSET time then defines the fluid type: it must exceed 3 minutes for a Type I, 30 minutes for a Type II and 80 minutes for a Type IV fluid. The aerodynamic FPET performance test involves measuring the Boundary Layer Displacement Thickness (BLDT) during fluid elimination on a flat plate in a wind tunnel at temperatures from 0 °C down to a possible −45 °C. Two take-off acceleration profiles can be simulated, one for large transport type aircraft, and the other for commuter-type aircraft. A fluid is considered acceptable at a temperature interval if its BLDT is below an acceptance criteria defined by BLDT measurements of a reference fluid tested simultaneously and the fluid elimination is below a given percentage depending on fluid type.</div>