Search engine for discovering works of Art, research articles, and books related to Art and Culture
Javascript must be enabled to continue!
Investigation of photo-chromic properties of remote phosphor film and white light emitting diode mixed with TiO2 particles
View through CrossRef
Based on the hot pressing method, the remote phosphor films are prepared by adding TiO2 particles into YAG:Ce and silicon binder, and then they are packaged into white light emitting diode (WLED) device with chip on board (COB) blue light source. The photo-chromic properties and mechanism are studied and calculated. Based on Mie theory and Henyey-Greenstein function, forward scattering is the main light scattering form of YAG:Ce phosphor powder, while the forward scattering intensity is close to the back scattering intensity of TiO2 particles. The emission spectral intensity and relative luminance of remote phosphor film change with increasing the concentration of TiO2 particles, and the optimum concentration is 0.966 g/cm3. Forward transmission intensity and back reflection intensity are calculated and analyzed, when the concentration of TiO2 is low, the forward transmission intensity of blue light is stronger than that of yellow light and the main transmission form is forward transmission, while the forward and backward intensity of yellow light are similar because of isotropy. With increasing the concentration of TiO2, the forward intensity of blue light gradually decreases, and the transmission intensity is lower than that of yellow light. The forward and backward intensity of yellow light reach their maxima when the TiO2 concentration is 0.966 g/cm3. The main reason for this phenomenon is that the increasing of the utilization ratio between blue light and transmission of yellow light is affected by the strong scattering ability of TiO2. Finally the WLEDs are packaged by remote phosphor films and COB blue light source, the luminous flux of WLED reaches 415.28 lm (at 300 mA and 9.3 V) at a concentration of 0.966 g/cm3, which is increased by 8.15% compared with the concentration in the case of no TiO2 mixing. Besides, the correlated color temperature changes from cool white 6900 K to warm white 3832 K gradually. Consequently, the adding of TiO2 particles can not only improve the emission intensity of remote phosphor film and the luminous flux of WLED, but also regulate the correlated color temperature.
Acta Physica Sinica, Chinese Physical Society and Institute of Physics, Chinese Academy of Sciences
Title: Investigation of photo-chromic properties of remote phosphor film and white light emitting diode mixed with TiO2 particles
Description:
Based on the hot pressing method, the remote phosphor films are prepared by adding TiO2 particles into YAG:Ce and silicon binder, and then they are packaged into white light emitting diode (WLED) device with chip on board (COB) blue light source.
The photo-chromic properties and mechanism are studied and calculated.
Based on Mie theory and Henyey-Greenstein function, forward scattering is the main light scattering form of YAG:Ce phosphor powder, while the forward scattering intensity is close to the back scattering intensity of TiO2 particles.
The emission spectral intensity and relative luminance of remote phosphor film change with increasing the concentration of TiO2 particles, and the optimum concentration is 0.
966 g/cm3.
Forward transmission intensity and back reflection intensity are calculated and analyzed, when the concentration of TiO2 is low, the forward transmission intensity of blue light is stronger than that of yellow light and the main transmission form is forward transmission, while the forward and backward intensity of yellow light are similar because of isotropy.
With increasing the concentration of TiO2, the forward intensity of blue light gradually decreases, and the transmission intensity is lower than that of yellow light.
The forward and backward intensity of yellow light reach their maxima when the TiO2 concentration is 0.
966 g/cm3.
The main reason for this phenomenon is that the increasing of the utilization ratio between blue light and transmission of yellow light is affected by the strong scattering ability of TiO2.
Finally the WLEDs are packaged by remote phosphor films and COB blue light source, the luminous flux of WLED reaches 415.
28 lm (at 300 mA and 9.
3 V) at a concentration of 0.
966 g/cm3, which is increased by 8.
15% compared with the concentration in the case of no TiO2 mixing.
Besides, the correlated color temperature changes from cool white 6900 K to warm white 3832 K gradually.
Consequently, the adding of TiO2 particles can not only improve the emission intensity of remote phosphor film and the luminous flux of WLED, but also regulate the correlated color temperature.
Related Results
Screening of color phosphor powders on CRT faceplates
Screening of color phosphor powders on CRT faceplates
Abstract— We studied the screening of color phosphor powders on CRT faceplates by photolithography. For photolithography, the phosphor particles should disperse perfectly in the dr...
Decolorization of textile wastewater by electrooxidation process using different anode materials: Statistical optimization
Decolorization of textile wastewater by electrooxidation process using different anode materials: Statistical optimization
AbstractThe presence of reactive dyes in textile wastewater is a serious environmental concern due to their associated mutagenic and carcinogenic effects. The present study aims to...
Photocatalytic Syntheis of L-Pipecolinic Acid from L-Lysine by Hollow Core-Shell Titania Particles
Photocatalytic Syntheis of L-Pipecolinic Acid from L-Lysine by Hollow Core-Shell Titania Particles
A possible approach for photocatalytic selective organic synthesis is utilization of photocatalysts of or in defined microstructures. We have reported [1,2] fabrication of a novel...
Reclaiming the Wasteland: Samson and Delilah and the Historical Perception and Construction of Indigenous Knowledges in Australian Cinema
Reclaiming the Wasteland: Samson and Delilah and the Historical Perception and Construction of Indigenous Knowledges in Australian Cinema
It was always based on a teenage love story between the two kids. One is a sniffer and one is not. It was designed for Central Australia because we do write these kids off there. N...
Synthesis and Characterization of MIL-100(Fe) Metal-Organic Framework on Titania as Visible Light-Active Photocatalyst for Bisphenol A Degradation
Synthesis and Characterization of MIL-100(Fe) Metal-Organic Framework on Titania as Visible Light-Active Photocatalyst for Bisphenol A Degradation
Titania (TiO2) is a widely utilized metal oxide nanomaterial used for pollutant degradation, yet its limited activity under visible light restricts its broader photocatalytic appli...
The Hydrothermal Synthesis of TiO2-GO with Enhance Photocatalytic Activity
The Hydrothermal Synthesis of TiO2-GO with Enhance Photocatalytic Activity
A composite material consisting of titanium dioxide and graphene oxide (TiO2–GO) was synthesized through a hydrothermal reaction. This reaction involved the use of Ti(SO4)2 in an e...
Photoelectron characteristics of ZnSe quantum dots-sensitized mesoporous La-doped nano-TiO2 film
Photoelectron characteristics of ZnSe quantum dots-sensitized mesoporous La-doped nano-TiO2 film
In the paper, the core-shell ZnSe quantum dots (QDs)-sensitized mesoporous La-doped nano-TiO2 thin film is prepared by a direct adsorption method. Photoelectron characteristics, ph...
The effect of ITO annealing on electrical characteristic of GaN based LED
The effect of ITO annealing on electrical characteristic of GaN based LED
In the recent years，more and more light-emitting diodes use indium tin oxide (ITO) as the current spreading layer. But if there is not any treatment, the electrical properties of l...