Numerical Research on Steady Coupling of Neutronics and Thermal-Hydraulics for a Molten Salt Reactor

The Molten Salt Reactor (MSR), which is one of the ‘Generation IV’ concepts, can be used for production of electricity, actinide burning, production of hydrogen, and production of fissile fuels. In this paper, a single-liquid-fueled MSR was selected for conceptual research. For this MSR, a ternary system of 15%LiF-58%NaF-27%BeF2 was proposed as the reactor fuel solvent, coolant and also moderator with ca. 1 mol% UF4 dissolving in it, which circulates through the whole primary loop accompanying fission reaction only in the core. The fuel salt flow makes the MSR different from the conventional reactors using solid fissile materials, and makes the neutronics and thermal-hydraulic coupled strongly, which plays the important role in the research of reactor safety analysis. Therefore, it’s necessary to study the coupling of neutronics and thermal-hydraulic. The theoretical models of neutronics and thermal-hydraulics under steady condition were conducted and calculated by numerical method in this paper. The neutronics model consists of two group neutron diffusion equations for fast and thermal neutron fluxes, and balance equations for six-group delayed neutron precursors considering flow effect. The thermal-hydraulic model was founded on the base of the fundamental conservation laws: the mass, momentum and energy conservation equations. These two models were coupled through the temperature and heat source. The spatial discretization of the above models is based on the finite volume method (FVM), and the thermal-hydraulic equations are computed by SIMPLER algorithm with domain extension method on the staggered grid system. The distribution of neutron fluxes, the distribution of the temperature and velocity and the distribution of the delayed neutron precursors in the core were obtained. The numerical calculated results show that, the fuel salt flow has little effect to the distribution of fast and thermal neutron fluxes and effective multiplication factor; however, it affects the distribution of the delayed neutron precursors significantly, especially long-lived one. In addition, it could be found that the delayed neutron precursors influence the neutronics slightly under the steady condition, and the flow could remove the heat generated by the neutron reactions easily to ensure the reactor safe. The obtained results serve some valuable information for the research and design of this new generation reactor.