Effect of Unguided Turning Angle and Trailing Edge Shape on Cooled Blade Loss

A significant part of the overall loss in modern gas turbines is the trailing edge loss. This loss is, more strongly than other constituents, affected by operation, because the trailing edge can significantly change its shape due to degradation. Also by manufacturing of new parts and reconditioning the same tolerances as in other parts of blade lead to higher deviations of aerodynamic characteristics. Therefore the understanding of trailing edge loss generation mechanisms is of utmost importance for a sound blade design. In this work the results of combined experimental and numerical investigation of the trailing edge impact on the transonic cooled blade loss are presented. This study comprises the investigation of the unguided flow angle and the trailing edge shape on the profile losses and a base pressure. The unguided flow angle characterizes the curvature distribution on the aerofoil suction side. The numerical and experimental investigation of transonic cooled turbine cascades have shown that the increase of the unguided flow angle results in loss reduction due to increase of the base pressure downstream of the trailing edge. At the same time the deviation of the trailing edge from a round shape has detrimental effect on performance and conducted investigations allow quantification of this effect. The measurements were performed in a transonic wind tunnel and numerical simulations were done using in-house 2D Navier-Stokes code. The comparison of calculations with measurements showed that they are in reasonable agreement. The validated numerical procedure has been used for demonstration of possibility to reduce loss in aerofoil with thick trailing edge by tuning of the unguided flow angle. The use of the thick trailing edges at HP cooled turbines reduces restriction on tolerances, improves of manufacturability and reduces cost.