ELID Mirror Surface Grinding for Concave Molds by Conductive Elastic Wheel Containing Carbon Black

Elastic grinding wheels have previously been adopted for the development of the mirror surface finishing method for concave spheres. In this study, new conductive elastic grinding wheels, to which electrolytic in-process dressing (ELID) can be applied, are developed; the aim of the study is to address the challenge of maintaining a constant removal rate for rubber bond wheels. When ELID grinding is performed using a non-diene (isobutane isoprene rubber, IIR)-based wheel, a larger removal amount is achieved, and a higher-quality surface is also achieved compared to a diene (acrylonitrile-butadiene rubber, NBR)-based wheel. In addition, to investigate the effect of grinding wheel bond hardness on the removal amount and ground shape accuracy, grinding wheels with various levels of hardness are prepared by controlling the amount of carbon black contained in them, and grinding experiments are conducted. Thus, a larger removal amount is achieved using a harder grinding wheel, but the roughness of the ground surfaces deteriorates. Therefore, in practice, it is necessary to select an appropriate grinding wheel that can achieve both productivity and surface quality. Finally, to obtain a high-quality mirror finish on a concave spherical surface, ELID grinding is performed on the workpieces as is done for spherical lens molds. Thus, high-quality mirror surfaces with roughness Ra < 10 nm were generated. When the work pieces are ground using a grinding wheel of the same radius, excessive removal occurs at the edge of the concave spherical profile, decreasing the form accuracy. Numerical simulation demonstrates that chamfering of the grinding wheel is effective for improving the shape accuracy. The results of this study are expected to contribute to automation and cost reduction in the mirror-finishing process for concave molds.