The accuracy of anatomic landmarks on the occlusal plane: a comparative study between conventional and 3D image method

Abstract Background To establish the occlusal plane, the conventional methods for facial analysis to gain accurate alignment of the occlusal plane are inadequate, while 3D technologies are an ideal diagnostic tool. The aims of this research are to compare the difference accuracy of anatomic landmarks on the occlusal plane and ala-tragus line between the conventional clinical method and 3D image method in both non-orthodontic and orthodontic treatment volunteers. Methods A total of 44 volunteers (22 non-orthodontic and 22 orthodontic treatment volunteers) with normal occlusion were selected. All volunteers received 2 operative methods for occlusal plane determination. In conventional method, the occlusal plane was defined by the fox plane line. The ala-tragus line was defined by the radio-opaque markers. In the 3D image method, the volunteers were recorded intraoral images, 3D facial images and CBCT images. A 3D virtual picture was created using EXOCAD® software. The occlusal plane was generated by the incisal and occlusal surfaces of the teeth. Both methods, the angles and distances between the occlusal plane and ala-tragus line were measured and compared statistically on both sides of each volunteer. Results Both volunteers’ group, the mean angles and distances between the occlusal plane-ala tragus line in the conventional method were reported to be significantly greater than the 3D method (P < 0.05). The percentage difference of angles in conventional method were reported to be significantly higher by 13.61–21.58% (p < 0.05) compared to the 3D method. The percentage difference of distances in the conventional method were reported to be significantly greater than the 3D method by 4.73–7.51% (p < 0.05). Conclusions Within the limitation of the study, it can be concluded that both conventional and digital methods for establishing the occlusal plane are not parallel to the occlusal plane. The occlusal plane and ala-tragus line in the conventional method and the 3D method were significantly different in terms of angles and distances in both non-orthodontic and orthodontic treatment volunteers. However, the deviation angle of both methods is approximately 13–20 degrees, which is clinically acceptable for occlusal plane establishment. The accuracy of both methods is still within the using in clinical implementation.