Javascript must be enabled to continue!
Nutrient content of fish powder from low value fish and fish byproducts
View through CrossRef
AbstractConsuming small‐sized fish species whole, and bones of large fish could contribute significantly to reducing the level of micronutrient and protein malnutrition. These fish products are more affordable and could therefore meet the needs of poor, vulnerable groups, particularly in rural and urban areas where limited economic resources prevent dietary diversity. The objectives of the study were to produce fish powder from dried edible byproducts from fish processing factories, an underutilized fish species, burrito and to determine the physical, micromineral, macronutrient and microbiological quality of the dried fish powder. Edible fish processing byproducts and an underutilized fish, burrito (Brachydeuterus auritus) were cleaned thoroughly and dried with a Council for Scientific and Industrial Research‐Food Research Institute (CSIR‐FRI) gas‐fuelled oven at 55°C for 8 h or until dried. The dried products were milled into powder, and packaged into polythene bags. Proximate analysis of the fish powder was done Official Methods of Analysis (AOAC) methods. Minerals and heavy metals in the fish powder were determined by atomic absorption spectrophotometry (AAS). Microbiological quality was determined by Nordic Committee on Food Analysis Method (NMLK) methods. Tuna trimmings contained 80.71 g/100 g protein, whereas burrito contained 70.40 g/100 g protein. Concentrations of cadmium, arsenic, and mercury varied from <1.00 to 1 mg/kg. Lead was found at 0.04 mg/100 g in tuna frames and gills only. All fish byproducts contained high levels of iron, for example, trimmings contained 16.58 mg/100 g, whereas tuna frames and gills also contained 16.82 and 19.54 mg/100 g, respectively. Burrito contained 8.92 mg/100 g. Zinc levels also ranged from 0.41 mg/100 g in tuna trimmings to 1.88 mg/100 g in tuna gills. The powdered samples according to the standards set by Ghana Standard Authority, were acceptable. Consuming small‐ sized fish species whole, and bones of large fish could contribute significantly to reducing the level of micronutrient and protein malnutrition. These are more affordable and could therefore meet the needs of poor, vulnerable groups.
Title: Nutrient content of fish powder from low value fish and fish byproducts
Description:
AbstractConsuming small‐sized fish species whole, and bones of large fish could contribute significantly to reducing the level of micronutrient and protein malnutrition.
These fish products are more affordable and could therefore meet the needs of poor, vulnerable groups, particularly in rural and urban areas where limited economic resources prevent dietary diversity.
The objectives of the study were to produce fish powder from dried edible byproducts from fish processing factories, an underutilized fish species, burrito and to determine the physical, micromineral, macronutrient and microbiological quality of the dried fish powder.
Edible fish processing byproducts and an underutilized fish, burrito (Brachydeuterus auritus) were cleaned thoroughly and dried with a Council for Scientific and Industrial Research‐Food Research Institute (CSIR‐FRI) gas‐fuelled oven at 55°C for 8 h or until dried.
The dried products were milled into powder, and packaged into polythene bags.
Proximate analysis of the fish powder was done Official Methods of Analysis (AOAC) methods.
Minerals and heavy metals in the fish powder were determined by atomic absorption spectrophotometry (AAS).
Microbiological quality was determined by Nordic Committee on Food Analysis Method (NMLK) methods.
Tuna trimmings contained 80.
71 g/100 g protein, whereas burrito contained 70.
40 g/100 g protein.
Concentrations of cadmium, arsenic, and mercury varied from <1.
00 to 1 mg/kg.
Lead was found at 0.
04 mg/100 g in tuna frames and gills only.
All fish byproducts contained high levels of iron, for example, trimmings contained 16.
58 mg/100 g, whereas tuna frames and gills also contained 16.
82 and 19.
54 mg/100 g, respectively.
Burrito contained 8.
92 mg/100 g.
Zinc levels also ranged from 0.
41 mg/100 g in tuna trimmings to 1.
88 mg/100 g in tuna gills.
The powdered samples according to the standards set by Ghana Standard Authority, were acceptable.
Consuming small‐ sized fish species whole, and bones of large fish could contribute significantly to reducing the level of micronutrient and protein malnutrition.
These are more affordable and could therefore meet the needs of poor, vulnerable groups.
Related Results
Social Economic Determinants of Adoption of Fish Farming in Gem Sub-County, Siaya County, Kenya
Social Economic Determinants of Adoption of Fish Farming in Gem Sub-County, Siaya County, Kenya
The demand for fish in Kenya has been steadily increasing, prompting the exploration of alternative methods such as fish farming to address this rising demand. However, the adoptio...
Mutu teh celup dengan campuran bubuk sereh (Cymbopogon citratus) dan bubuk kelor (Moringa oleifera)
Mutu teh celup dengan campuran bubuk sereh (Cymbopogon citratus) dan bubuk kelor (Moringa oleifera)
Moringa is one of potential raw material of herbal tea. Moringa tea had disadvantage is a off-flavour aroma. The addition of lemongrass hopefully can reduce the off-flavour aroma ...
Evaluation of TRICHONEMTM as Anti-Dandruff and Hair growth promoter in young adults
Evaluation of TRICHONEMTM as Anti-Dandruff and Hair growth promoter in young adults
The aim of the present study is to formulate and evaluate herbal Anti dandruff hair wash powder containing eighteen herbal ingredients and soluble egg shell membrane in a proportio...
Performance evaluation of graphite and titanium oxide powder mixed dielectric for electric discharge machining of Ti–6Al–4V
Performance evaluation of graphite and titanium oxide powder mixed dielectric for electric discharge machining of Ti–6Al–4V
AbstractTi–6Al–4V is the most commonly used titanium alloy in aerospace, marine, and biomedical applications. Due to the properties of poor machinability in conventional machining,...
A Combined Experimental-Numerical Method to Evaluate Powder Thermal Properties in Laser Powder Bed Fusion
A Combined Experimental-Numerical Method to Evaluate Powder Thermal Properties in Laser Powder Bed Fusion
Powder bed metal additive manufacturing (AM) utilizes a high-energy heat source scanning at the surface of a powder layer in a pre-defined area to be melted and solidified to fabri...
Toxicological Qualities and Detoxification Trends of Fruit Byproducts for Valorization
Toxicological Qualities and Detoxification Trends of Fruit Byproducts for Valorization
The abundant and renewable resources from fruit byproducts are getting emphasis on their valorization. These byproducts are suspected of possible toxications during cultivation, ha...
Determination of Nutrient Solutions for Potato (Solanum tuberosum L.) Seed Production under Aeroponics Production System
Determination of Nutrient Solutions for Potato (Solanum tuberosum L.) Seed Production under Aeroponics Production System
AbstractIn soilless culture like aeroponics, nutrient optimization is the most critical factor to produce high quality and high yield of clean potato seed. Each crop has an optimum...
Economic Performance and Nutrient Use Efficiency of Onion (Allium Cepa L.) Under N, K and S Nutrient Combinations in Northern Ethiopia
Economic Performance and Nutrient Use Efficiency of Onion (Allium Cepa L.) Under N, K and S Nutrient Combinations in Northern Ethiopia
Background:Nitrogen (N), potassium (K) and sulfur (S) nutrient elements play an important role in the growth and bulb yield of onion. However, imbalanced nutrient application leads...

