Javascript must be enabled to continue!
Design of a broadband and high-gain shared-aperture fabry-perot resonator magneto-electric microstrip antenna
View through CrossRef
The demands for highly directive antennas are becoming more stringent, especially in microwave regions. Traditional ways to enhance the antenna gain such as reflectors, dielectric lenses, waveguide horns and microstrip antenna arrays suffer design complexity, high cost and power loss in the feeding network, so it is urgent to find a simple way to solve the problem. Fabry-Perot (F-P) antenna has a high directivity and low sidewall, owing to the resonance of the cavity in a cophasal and tapered field distribution along the lateral direction. However, the disadvantage of F-P antenna is obvious for the inherently narrow gain bandwidth which inhibits their many applications. In this paper, a broadband and high-gain shared-aperture F-P resonator magneto-electric (ME) microstrip antenna working at X band is designed and fabricated. In order to design a wideband metamaterial superstrate unit, the structure with two different frequency selective surface (FSS) layers is presented: the metal pattern at the top of the unit is a square patch and has a high reflection coefficient in the high frequency band, and at the bottom the metal pattern is a cross patch, it has a high reflection coefficient in the low frequency band, therefore, the whole unit should resonate in a broadband frequency range. Theoretical analysis and simulation result indicate that the unit has a linearly increasing phase response and a high reflection coefficient across a broadband range and it has the potential to construct a wideband F-P resonator antenna. In the proposed antenna, a novel wideband ME microstrip antenna is used as the feeding source. For the antenna covers the whole X band, the bandwidth of the F-P resonator superstrate should be further expanded. Simulated calculation results indicate that different sizes of two-layer FSSs have different reflection phases but the same coefficient, therefore a shared-aperture structure with three different sizes of FSSs is obtained. The arrangement utilizes the phase compensation property along different FSSs, and broadens the gain enhancement bandwidth effectively. When the superstrate is set to be approximately 15.5 mm above the ground plane of the ME antenna, the antenna possesses an impedance bandwidth of 44.7% for the reflection coefficient (S11) below -10 dB from 7.8 GHz to 12.3 GHz, covering the whole X band. From 7.9 GHz to 12.1 GHz, the antenna has an obvious gain enhancement, with a peak of 7 dB. Numerical and experimental results indicate that compared with the traditional F-P resonator structure, the shared-aperture metamaterial superstrate can effectively broaden the antenna gain enhancement bandwidth, and it has great application values for designing new broadband metamaterial superstrate high-gain antennas.
Acta Physica Sinica, Chinese Physical Society and Institute of Physics, Chinese Academy of Sciences
Title: Design of a broadband and high-gain shared-aperture fabry-perot resonator magneto-electric microstrip antenna
Description:
The demands for highly directive antennas are becoming more stringent, especially in microwave regions.
Traditional ways to enhance the antenna gain such as reflectors, dielectric lenses, waveguide horns and microstrip antenna arrays suffer design complexity, high cost and power loss in the feeding network, so it is urgent to find a simple way to solve the problem.
Fabry-Perot (F-P) antenna has a high directivity and low sidewall, owing to the resonance of the cavity in a cophasal and tapered field distribution along the lateral direction.
However, the disadvantage of F-P antenna is obvious for the inherently narrow gain bandwidth which inhibits their many applications.
In this paper, a broadband and high-gain shared-aperture F-P resonator magneto-electric (ME) microstrip antenna working at X band is designed and fabricated.
In order to design a wideband metamaterial superstrate unit, the structure with two different frequency selective surface (FSS) layers is presented: the metal pattern at the top of the unit is a square patch and has a high reflection coefficient in the high frequency band, and at the bottom the metal pattern is a cross patch, it has a high reflection coefficient in the low frequency band, therefore, the whole unit should resonate in a broadband frequency range.
Theoretical analysis and simulation result indicate that the unit has a linearly increasing phase response and a high reflection coefficient across a broadband range and it has the potential to construct a wideband F-P resonator antenna.
In the proposed antenna, a novel wideband ME microstrip antenna is used as the feeding source.
For the antenna covers the whole X band, the bandwidth of the F-P resonator superstrate should be further expanded.
Simulated calculation results indicate that different sizes of two-layer FSSs have different reflection phases but the same coefficient, therefore a shared-aperture structure with three different sizes of FSSs is obtained.
The arrangement utilizes the phase compensation property along different FSSs, and broadens the gain enhancement bandwidth effectively.
When the superstrate is set to be approximately 15.
5 mm above the ground plane of the ME antenna, the antenna possesses an impedance bandwidth of 44.
7% for the reflection coefficient (S11) below -10 dB from 7.
8 GHz to 12.
3 GHz, covering the whole X band.
From 7.
9 GHz to 12.
1 GHz, the antenna has an obvious gain enhancement, with a peak of 7 dB.
Numerical and experimental results indicate that compared with the traditional F-P resonator structure, the shared-aperture metamaterial superstrate can effectively broaden the antenna gain enhancement bandwidth, and it has great application values for designing new broadband metamaterial superstrate high-gain antennas.
Related Results
Magneto-Electric Antenna and Its Application in Geosteering Tool Design
Magneto-Electric Antenna and Its Application in Geosteering Tool Design
Using coil antennae as transmitter and receiver to develop a geosteering tool, one has to increase the spacing between the transmitter and receiver to detect formation boundaries f...
5.8 GHz Circularly Polarized Rectangular Microstrip Antenna Arrays simulation for Point-to-Point Application
5.8 GHz Circularly Polarized Rectangular Microstrip Antenna Arrays simulation for Point-to-Point Application
In this paper, the design and simulation of rectangular microstrip antenna arrays for improving antenna gain is performed for point-to-point application. The proposed design is com...
Bandwidth Enhancement of Rectangular Microstrip Patch Antenna using Defected Ground Structure
Bandwidth Enhancement of Rectangular Microstrip Patch Antenna using Defected Ground Structure
<p>This paper presents the bandwidth enhancement of a Proximity Coupled Feed Rectangular Microstrip Patch Antenna using a new Defected Ground Structure - an ‘inverted SHA’ sh...
Peculiarities of adaptive signal processing in circular antenna arrays
Peculiarities of adaptive signal processing in circular antenna arrays
Formulation of the problem. Today, antenna arrays are often used as directional antennas of different radio systems. The main advantages of the such antennas over the mechanically ...
EVALUASI DAMPAK PROGRAM BROADBAND LEARNING CENTER DI TAMAN PRESTASI SURABAYA
EVALUASI DAMPAK PROGRAM BROADBAND LEARNING CENTER DI TAMAN PRESTASI SURABAYA
Broadband Learning Center adalah program pelatihan komputer gratis yang disediakan oleh Pemerintah Kota Surabaya yang bertujuan untuk menjawab permasalahan di Surabaya seperti masy...
Design and simulation of a 2-shaped Slotloaded Rectangular Microstrip Patch
Design and simulation of a 2-shaped Slotloaded Rectangular Microstrip Patch
A design of 2-slot loaded rectangular microstrip patch antenna was worked out. The aim of this design is to improve the parameters of microstip antenna .This design shows that ther...
Design and Analysis of Tri-bandsTriangular Shape Fractal Antenna for Wireless Applications
Design and Analysis of Tri-bandsTriangular Shape Fractal Antenna for Wireless Applications
Abstract
In this paper fractal antenna is proposed for wide band applications. Proposed Antenna is having resonance frequency of 5 GHz and it has triangular patch with 36mm...
O-Shape Fractal Antenna Optimized Design with Broad Bandwidth and High Gain for 6G Mobile Communication Devices
O-Shape Fractal Antenna Optimized Design with Broad Bandwidth and High Gain for 6G Mobile Communication Devices
Optimization of antenna parameters is important for achieving the best design that has higher results for gain and bandwidth while also having a smaller size. One such antenna desi...


