Debris flow magnitude estimation based on infrasound and seismic signals

<p>With the rapid socio-economic development of European mountain areas, the automatic detection and identification of mass movements like landslides, debris flows, and avalanches become more and more important to mitigate related risks by means of early warning systems. Past studies showed that such processes induce characteristic seismic and acoustic signals, the latter mostly in the infrasonic spectrum which can thus be used for event detection. Several investigations have already addressed signal processing and detection methods based on seismic or infrasound sensors. However, for developing an efficient warning system, not only the detection of events is important but also the identification of the event type (e.g. debris flow vs debris flood) and the estimation of its magnitude. So far, no method for such objectives has been developed which is based on the combination of both seismic and infrasonic signals.</p><p>This work presents a first approach to identify debris flows and debris floods magnitude based on the integration of infrasound and seismic data. First analysis shows that, for peak discharge, the use of infrasound amplitudes with a power curve fitting offers a good approach for finding an initial relationship between the recorded signals and this event parameter. For an estimation of the total volume, the discharge calculated with the relationship for peak discharge is integrated over the entire detection time of an event. Calculation of the peak discharge based on infrasound data offers a good approximation, but, for the calculation of the total volume, this method shows still a wide variance.</p><p>The method will be applied to seismic and infrasound data collected on three different test sites in the Alps: Gadria (South Tyrol, Italy), Lattenbach (Tyrol, Austria), and Cancia (Belluno, Italy).</p>