DEM Parameter Calibration of Maize Seeds and the Effect of Rolling Friction

A set of suitable parameter values is crucial in discrete element method (DEM) simulations. As a non-spherical particle, the coefficients of rolling friction between maize seed particles and between the seed particles and the boundary are hard to measure directly and must be obtained by calibration. In this paper, taking three representative maize varieties as research objects, the necessity for the accurate calibration of the coefficients of rolling friction between seed particles and between seed particles and boundaries is investigated. Subsequently, by studying the sensitivity of the coefficients of rolling friction between seed particles and between seed particles and the boundary to the angle of repose test, the methods used to calibrate the coefficients of rolling friction between seed particles and between the particles and the boundary are determined. It can be seen from the results that the coefficients of rolling friction between the seed particles and between the seed particles and the boundary have a significant influence on the test results, so these two parameters must be accurately calibrated. Additionally, the coefficient of rolling friction between seed particles and the boundary has no effect on the piling angle, but the piling angle is highly sensitive to the coefficient of rolling friction between seed particles. By comparing the simulation results and the experimental results in the lifting cylinder and “self-flow screening” tests, the calibrated seed parameters were found to be accurate and valid.