Javascript must be enabled to continue!
Seafloor displacements across the mid-ocean ridge eruption cycle modulated by mush zone viscosity
View through CrossRef
Mid-ocean ridges (MORs) are extremely active volcanic systems where dike intrusions and eruptions recur on decadal time scales. Their submarine setting has long made in-situ observations of active deformation extremely challenging, hindering insight into sub-seafloor deformation sources. Recent progress in seafloor geodesy is rapidly changing this state of affairs, by providing measurements of rapid seafloor displacements throughout the MOR eruption cycle. These novel datasets therefore call for the development of new models to fully realize their potential. Importantly, MOR plumbing systems have been particularly well imaged and typically comprise shallow reservoirs termed axial melt lenses (AMLs) lying above, and embedded within a lower crustal mush zone. Leveraging this knowledge, we design 2-D (forward) finite-element models of the active seafloor deformation that should characterize a cycle of steady AML inflation followed by an instantaneous dike intrusion and AML drainage. The AML lies at the base of an elastic lithosphere, and atop a Maxwell viscoelastic mush zone, with viscosity ηM, that reaches Moho depths and is laterally confined to the axial domain. The underlying asthenosphere is viscoelastic with a viscosity of 10¹⁸ Pa.s. Our models treat AMLs as a tensile dislocation that opens at a specified rate, corresponding to a constant replenishment flux. AML replenishment manifests as distributed seafloor uplift. When ηM ≥ 10¹⁸ Pa.s, our models resemble elastic half-space end-members. Lower values of ηM however exert a damping effect on seafloor uplift rates, which slow down significantly from beginning to end of a replenishment phase. When the AML suddenly drains and/or when a dike suddenly opens, low mush zone viscosities result in a transient phase of post-drainage and post-diking relaxation, manifesting as steadily vanishing seafloor uplift and seafloor subsidence, respectively. We use our numerical simulations to revisit estimates of AML inflation at the East Pacific Rise (9°50′N) using seafloor uplift rates (up to ~7 cm/yr) measured by Nooner et al. (2014) between 2009 and 2011, i.e., 4 to 6 years following the 2005-2005 eruption. If we assume a strong mush (ηM >10¹⁸ Pa.s), the observed uplift requires an AML replenishment rate of ~150 m³/yr per meter along the ridge axis, whereas a very weak mush (ηM
Title: Seafloor displacements across the mid-ocean ridge eruption cycle modulated by mush zone viscosity
Description:
Mid-ocean ridges (MORs) are extremely active volcanic systems where dike intrusions and eruptions recur on decadal time scales.
Their submarine setting has long made in-situ observations of active deformation extremely challenging, hindering insight into sub-seafloor deformation sources.
Recent progress in seafloor geodesy is rapidly changing this state of affairs, by providing measurements of rapid seafloor displacements throughout the MOR eruption cycle.
These novel datasets therefore call for the development of new models to fully realize their potential.
Importantly, MOR plumbing systems have been particularly well imaged and typically comprise shallow reservoirs termed axial melt lenses (AMLs) lying above, and embedded within a lower crustal mush zone.
Leveraging this knowledge, we design 2-D (forward) finite-element models of the active seafloor deformation that should characterize a cycle of steady AML inflation followed by an instantaneous dike intrusion and AML drainage.
The AML lies at the base of an elastic lithosphere, and atop a Maxwell viscoelastic mush zone, with viscosity ηM, that reaches Moho depths and is laterally confined to the axial domain.
The underlying asthenosphere is viscoelastic with a viscosity of 10¹⁸ Pa.
s.
Our models treat AMLs as a tensile dislocation that opens at a specified rate, corresponding to a constant replenishment flux.
AML replenishment manifests as distributed seafloor uplift.
When ηM ≥ 10¹⁸ Pa.
s, our models resemble elastic half-space end-members.
Lower values of ηM however exert a damping effect on seafloor uplift rates, which slow down significantly from beginning to end of a replenishment phase.
When the AML suddenly drains and/or when a dike suddenly opens, low mush zone viscosities result in a transient phase of post-drainage and post-diking relaxation, manifesting as steadily vanishing seafloor uplift and seafloor subsidence, respectively.
We use our numerical simulations to revisit estimates of AML inflation at the East Pacific Rise (9°50′N) using seafloor uplift rates (up to ~7 cm/yr) measured by Nooner et al.
(2014) between 2009 and 2011, i.
e.
, 4 to 6 years following the 2005-2005 eruption.
If we assume a strong mush (ηM >10¹⁸ Pa.
s), the observed uplift requires an AML replenishment rate of ~150 m³/yr per meter along the ridge axis, whereas a very weak mush (ηM.
Related Results
An experimental study of melt migration in crystal-rich mushes
An experimental study of melt migration in crystal-rich mushes
<p>Increasingly, volcanologists model mature volcanic systems as being fed by stratified magma reservoirs, that is, small lenses of eruptible magma suspended within a...
Deformation driven magma ascent in stratified magma reservoirs: an experimental study
Deformation driven magma ascent in stratified magma reservoirs: an experimental study
<p>Mature volcanic systems (e.g., Yellowstone, USA; Campi Flegrei, Italy) are fed by stratified magma reservoirs &#8211; small bodies of eruptible, crystal-po...
Experimental Simulation of Europan Seafloor Hydrothermal Systems
Experimental Simulation of Europan Seafloor Hydrothermal Systems
Introduction: Jupiter’s moon Europa is proposed to host a global liquid water ocean that is in contact with a silicate interior (Sotin et al., 2009). Similar to Earth’s oceans, wat...
Decompaction-Driven Overpressurisation of Mid-Ocean Ridge Magma Lenses
Decompaction-Driven Overpressurisation of Mid-Ocean Ridge Magma Lenses
Seismic imaging of magmatically robust mid-ocean ridges (MORs) reveals the presence of sill-shaped axial melt lenses (AMLs) located a few kilometres below the seafloor, overlying a...
An object-based seafloor classification tool using recognition of empirical angular backscatter signatures
An object-based seafloor classification tool using recognition of empirical angular backscatter signatures
This study presents a novel concept of seafloor acoustic mapping utilizing the angular dependence of high density soundings. A prerequisite is that data should result from a backsc...
Mid‐ocean ridge magma chambers
Mid‐ocean ridge magma chambers
Geophysical evidence precludes the existence of a large, mainly molten magma chamber beneath portions of the East Pacific Rise (EPR). A reasonable model, consistent with these data...
The role of plume-ridge decoupling on rapid plate motion and intraplate volcanism
The role of plume-ridge decoupling on rapid plate motion and intraplate volcanism
The migration of mid-ocean ridges is driven by asymmetric plate motions on either ridge flank transmitted from far-field subduction forces. Within this model, the geometry and loca...
Status of global seafloor mapping effort and priority areas for future mapping
Status of global seafloor mapping effort and priority areas for future mapping
Several global and regional initiatives exist to increase the proportion of seafloor mapped by direct measurements, brought together through international collaborations, of which ...

