Search engine for discovering works of Art, research articles, and books related to Art and Culture
ShareThis
Javascript must be enabled to continue!

Dynamics of charge movement in ∞-Al2O3:C,Mg using thermoluminescence phototransferred and optically stimulated luminescence

View through CrossRef
The dosimetric features of ∞-Al2O3:C,Mg have been investigated for unannealed and annealed samples. The unannealed sample is referred to as sample A whereas the samples annealed at 700, 900 and 1200°C for 15 minutes each are referred to as samples B, C and D respectively. A glow curve of unannealed ∞-Al2O3:C,Mg measured at 1°C/s after irradiation to 2.0 Gy consists of peaks at 43, 73, 164, 195, 246, 284, 336 and 374°C respectively. For sample B (annealed at 700°C), a glow curve measured at 1°C/s after irradiation to 3.0 Gy has peaks at 46, 76, 100, 170, 199, 290, 330 and 375°C whereas the glow curve of sample C (annealed at 900°C) recorded under the same conditions consists of peaks at 49, 80, 100, 174, 206, 235, 290, 335 and 375°C respectively. Sample D (annealed at 1200°C) is the most sensitive of the four samples. A glow curve of sample D measured at 1°C/s after irradiation to 0.2 Gy has peaks at 52, 82, 102, 174, 234, 288 and 384°C respectively. The peaks are labelled I-VIII in order of appearance. The 100°C peak, labelled IIa, is induced by annealing at or above 700°C. The dose response of these peaks was studied for doses within 0.1-8.2 Gy. The reported peaks follow first-order kinetics irrespective of annealing temperature. Peaks I-III of each sample are reproduced under phototransfer for preheating up to 400°C. For the unannealed sample, the reproduced peaks are labelled A1-A3 whereas for the annealed samples, they are labelled B1-B3, C1-C3 and D1-D3 respectively. The annealing-induced peak at 100°C is reproduced as B2a, C2a and D2a for samples B, C and D respectively. A PTTL peak labelled C2b or D2b is also observed near 140°C in samples C and D. In addition to these PTTL peaks, a PTTL peak corresponding to peak IV is also found for sample D and for the unannealed sample. As the corresponding conventional peaks, the PTTL peaks of each sample follow first-order kinetics. Peak I and its corresponding PTTL peak for each sample are unstable and fade to a minimal level after 300 s of storage time. On the other hand, peak II of each sample and its corresponding PTTL peak could still be observed with delay up to 5000 s. Peak III of the unannealed sample remains stable with storage time up to 48 hours. Irrespective of annealing, the trap corresponding to peak III is the most sensitive to optical stimulation. Time-dependent profiles of PTTL from unannealed and annealed ∞-Al2O3:C,Mg were also studied. The mathematical analysis of the PTTL time-response profiles is based on experimental results. The role of various electron traps in PTTL was determined by using pulse annealing and by monitoring the dependence of peak intensity on duration of illumination for peaks not removed by preheating. The presence and role of deep traps were further demonstrated with thermally assisted optically stimulated luminescence. For the unannealed sample, the activation energy for thermal assistance is 0.033 ± 0.001 eV and the activation energy for thermal i quenching is 1.043 ± 0.001 eV. For sample C, the activation energy for thermal assistance is 0.044 ± 0.003 eV whereas that for thermal quenching is 1.110 ± 0.006 eV. The values for the activation energy for thermal assistance are lower than those reported in literature. Only the values for the activation energy for thermal quenching are somewhat comparable to values reported elsewhere.
Rhodes University
Title: Dynamics of charge movement in ∞-Al2O3:C,Mg using thermoluminescence phototransferred and optically stimulated luminescence
Description:
The dosimetric features of ∞-Al2O3:C,Mg have been investigated for unannealed and annealed samples.
The unannealed sample is referred to as sample A whereas the samples annealed at 700, 900 and 1200°C for 15 minutes each are referred to as samples B, C and D respectively.
A glow curve of unannealed ∞-Al2O3:C,Mg measured at 1°C/s after irradiation to 2.
0 Gy consists of peaks at 43, 73, 164, 195, 246, 284, 336 and 374°C respectively.
For sample B (annealed at 700°C), a glow curve measured at 1°C/s after irradiation to 3.
0 Gy has peaks at 46, 76, 100, 170, 199, 290, 330 and 375°C whereas the glow curve of sample C (annealed at 900°C) recorded under the same conditions consists of peaks at 49, 80, 100, 174, 206, 235, 290, 335 and 375°C respectively.
Sample D (annealed at 1200°C) is the most sensitive of the four samples.
A glow curve of sample D measured at 1°C/s after irradiation to 0.
2 Gy has peaks at 52, 82, 102, 174, 234, 288 and 384°C respectively.
The peaks are labelled I-VIII in order of appearance.
The 100°C peak, labelled IIa, is induced by annealing at or above 700°C.
The dose response of these peaks was studied for doses within 0.
1-8.
2 Gy.
The reported peaks follow first-order kinetics irrespective of annealing temperature.
Peaks I-III of each sample are reproduced under phototransfer for preheating up to 400°C.
For the unannealed sample, the reproduced peaks are labelled A1-A3 whereas for the annealed samples, they are labelled B1-B3, C1-C3 and D1-D3 respectively.
The annealing-induced peak at 100°C is reproduced as B2a, C2a and D2a for samples B, C and D respectively.
A PTTL peak labelled C2b or D2b is also observed near 140°C in samples C and D.
In addition to these PTTL peaks, a PTTL peak corresponding to peak IV is also found for sample D and for the unannealed sample.
As the corresponding conventional peaks, the PTTL peaks of each sample follow first-order kinetics.
Peak I and its corresponding PTTL peak for each sample are unstable and fade to a minimal level after 300 s of storage time.
On the other hand, peak II of each sample and its corresponding PTTL peak could still be observed with delay up to 5000 s.
Peak III of the unannealed sample remains stable with storage time up to 48 hours.
Irrespective of annealing, the trap corresponding to peak III is the most sensitive to optical stimulation.
Time-dependent profiles of PTTL from unannealed and annealed ∞-Al2O3:C,Mg were also studied.
The mathematical analysis of the PTTL time-response profiles is based on experimental results.
The role of various electron traps in PTTL was determined by using pulse annealing and by monitoring the dependence of peak intensity on duration of illumination for peaks not removed by preheating.
The presence and role of deep traps were further demonstrated with thermally assisted optically stimulated luminescence.
For the unannealed sample, the activation energy for thermal assistance is 0.
033 ± 0.
001 eV and the activation energy for thermal i quenching is 1.
043 ± 0.
001 eV.
For sample C, the activation energy for thermal assistance is 0.
044 ± 0.
003 eV whereas that for thermal quenching is 1.
110 ± 0.
006 eV.
The values for the activation energy for thermal assistance are lower than those reported in literature.
Only the values for the activation energy for thermal quenching are somewhat comparable to values reported elsewhere.

Related Results

Thermoluminescence and optically stimulated luminescence characteristics of α-Al2O3:C crystal
Thermoluminescence and optically stimulated luminescence characteristics of α-Al2O3:C crystal
In this work,α-Al2O3:C crystal was grown by temperature gradient technique using α-Al2O3 and graphite powder as raw materials, and the thermoluminescence (TL) and optically stimula...
Karakterisasi Sensor Liquefied Petroleum Gas (LPG) dari Bahan SnO2 Didoping dengan Al2O3
Karakterisasi Sensor Liquefied Petroleum Gas (LPG) dari Bahan SnO2 Didoping dengan Al2O3
Karakterisasi terhadap sensor gas LPG dari bahan SnO2 didoping dengan Al2O3 telah dilakukan. Sampel dibuat dengan persentase doping 0%, 2%, 4%, 6%, 8% dan 10% mol terhadap bahan da...
A SULPHIDE CAPACITY PREDICTION MODEL OF BLAST FURNACE SLAG
A SULPHIDE CAPACITY PREDICTION MODEL OF BLAST FURNACE SLAG
A sulphide capacity prediction model of CaO-SiO2-MgO-Al2O3 slags has been developed based on the ion and molecule coexistence theory(IMCT). Sulphide capacity(Cs) of slag for blast ...
Preparation of high purity α-Al2O3 from industrial aluminum hydroxide
Preparation of high purity α-Al2O3 from industrial aluminum hydroxide
Aluminum oxide (alumina; Al2O3) has advantages such as its thermal, chemical, and physical properties when compared with several ceramics materials. It is widely used in ceramics s...
Phase Equilibria Studies in the CaO-MgO-Al2O3-SiO2 System with Al2O3/SiO2 Weight Ratio of 0.4
Phase Equilibria Studies in the CaO-MgO-Al2O3-SiO2 System with Al2O3/SiO2 Weight Ratio of 0.4
With the raw materials for ironmaking becoming increasingly complex, more accurate phase equilibrium information on the slag is needed to refine the blast furnace operation to redu...
Thermal Performance of Hybrid-Inspired Coolant for Radiator Application
Thermal Performance of Hybrid-Inspired Coolant for Radiator Application
Due to the increasing demand in industrial application, nanofluids have attracted the considerable attention of researchers in recent decades. The addition of nanocellulose (CNC) w...

Back to Top