Experimental Investigation of the Active Flow Control over a Cranked-Delta Wing

A series of experiments was carried out to investigate the effects of active flow control on the aerodynamic characteristics of a cranked-delta-wing model at a subsonic speed. A dielectric barrier discharge (DBD) plasma actuator was used to improve the aerodynamic performance of the half-span cranked-delta-wing model at various angles of attack. The model had inboard and outboard sweepback angles of 57 and 38 deg, respectively. The surface pressure distribution was obtained at five streamwise stations and at two ray stations. All data were obtained at a constant Reynolds number of [Formula: see text] and at various angles of attack: [Formula: see text]. The results showed that the pulsed DBD plasma actuator improved the aerodynamic performance of the cranked-delta-wing model by preventing flow separation at high angles of attack. The deep stall angle of attack was delayed up to 6 deg, and the poststall suction coefficient was increased approximately 30% at an angle of attack of about [Formula: see text] when the pulsed DBD plasma was applied at its optimum condition ([Formula: see text] and duty [Formula: see text]). It was found that the pulsed plasma actuator suppressed the wake flow in the forward portion of the wing at poststall angles of attack, thus delaying the flow separation. However, the effects of the DBD actuator at very high angles of attack on the flow reattachment process at the rear portion of the wing for the present DBD setting were seen to be minimal. The induced flow by the pulsed DBD plasma actuator influenced the vortex merging phenomena and delayed the onset of the outer vortex burst at prestall angles of attack.