Javascript must be enabled to continue!
PERFORMANCE OF NATURAL REFRIGERANTS IN TWO PHASE FLOW
View through CrossRef
The search for alternative environmentally friendly refrigerants have never been so crucial with the increasing demand for effective cooling of increasing miniaturization of our heat exchanging devices in the ever expanding air-conditioning and refrigeration industry. Although propane (R290) and ammonia (R717), natural refrigerants, have been around for decades, their two-phase thermal performance in small channels has yet to be fully investigated. Predictions of the heat transfer using correlations developed based on past experimental data have shown poor agreements, with more correlations being developed to date. This research was done to investigate the optimized conditions for the two-phase boiling heat transfer coefficient of R290 and R717 where the contributions from nucleate boiling and forced convective are represented explicitly. Multi-objective Genetic Algorithm (MOGA) is utilized for the simultaneous maximization of nucleate boiling and forced convective, two conflicting phenomena – the former generally significant in the low vapor quality region while the latter in the high quality region. A superposition correlation is used as it sums up both contributions. Two phased-out refrigerants, R134a and R22 are also being research here for comparison purposes. The range of MOGA design parameters set for mass flux, G, is between 100 - 300 kg/m2.s, heat flux q between 5 - 30 kW/m2 and vapor quality, x for 0.0009 - 0.9. The optimization is done for 3 mm channel diameter with saturation temperature at 10˚C. The optimized results showed a strong contribution of each nucleate boiling and forced convective for R717 with increasing vapor quality, compared to the other three refrigerants. The optimized value of the total heat transfer coefficient for R717 could reach up to 90 kW/m2.K and for R290 up to 12 kW/m2.K compared to R134a and R22 at 6 kW/m2.K and 5 kW/m2.K respectively. At lower vapor quality, the nucleate boiling contributes more to the total heat transfer coefficient, and suppressed due to forced convective as the vapor quality reaches middle range. The theoretical results indicate the potential of R717 and R290 as replacement refrigerants for R22 and R134a with further verifications to be done with correlations not using the superposition method.
Title: PERFORMANCE OF NATURAL REFRIGERANTS IN TWO PHASE FLOW
Description:
The search for alternative environmentally friendly refrigerants have never been so crucial with the increasing demand for effective cooling of increasing miniaturization of our heat exchanging devices in the ever expanding air-conditioning and refrigeration industry.
Although propane (R290) and ammonia (R717), natural refrigerants, have been around for decades, their two-phase thermal performance in small channels has yet to be fully investigated.
Predictions of the heat transfer using correlations developed based on past experimental data have shown poor agreements, with more correlations being developed to date.
This research was done to investigate the optimized conditions for the two-phase boiling heat transfer coefficient of R290 and R717 where the contributions from nucleate boiling and forced convective are represented explicitly.
Multi-objective Genetic Algorithm (MOGA) is utilized for the simultaneous maximization of nucleate boiling and forced convective, two conflicting phenomena – the former generally significant in the low vapor quality region while the latter in the high quality region.
A superposition correlation is used as it sums up both contributions.
Two phased-out refrigerants, R134a and R22 are also being research here for comparison purposes.
The range of MOGA design parameters set for mass flux, G, is between 100 - 300 kg/m2.
s, heat flux q between 5 - 30 kW/m2 and vapor quality, x for 0.
0009 - 0.
9.
The optimization is done for 3 mm channel diameter with saturation temperature at 10˚C.
The optimized results showed a strong contribution of each nucleate boiling and forced convective for R717 with increasing vapor quality, compared to the other three refrigerants.
The optimized value of the total heat transfer coefficient for R717 could reach up to 90 kW/m2.
K and for R290 up to 12 kW/m2.
K compared to R134a and R22 at 6 kW/m2.
K and 5 kW/m2.
K respectively.
At lower vapor quality, the nucleate boiling contributes more to the total heat transfer coefficient, and suppressed due to forced convective as the vapor quality reaches middle range.
The theoretical results indicate the potential of R717 and R290 as replacement refrigerants for R22 and R134a with further verifications to be done with correlations not using the superposition method.
Related Results
Characterization of Oil-Water Two-phase Flow Patterns in Vertical Upward Flow Pipes Based on Fractal and Chaotic Time Series Analysis
Characterization of Oil-Water Two-phase Flow Patterns in Vertical Upward Flow Pipes Based on Fractal and Chaotic Time Series Analysis
Abstract
Characterization of oil-water two-phase flow patterns in vertical upward oil-water two-phase flow having an inner diameter 18mm are elucidated based on f...
Ecofriendly Refrigerants
Ecofriendly Refrigerants
The depletion of ozone layer and green house effects are worldwide problem. Refrigerants are part and source of depletion of ozone layer. As we using these Ecofriendly refrigerants...
Multiphase Flow Metering:An Evaluation of Discharge Coefficients
Multiphase Flow Metering:An Evaluation of Discharge Coefficients
Abstract
The orifice discharge coefficient (CD) is the constant required to correct theoretical flow rate to actual flow rate. It is known that single phase orifi...
Refrigerant Mixtures
Refrigerant Mixtures
Evolution of refrigerants has a history since the introduction of air conditioning systems by Sir Willis Carrier. The first generation air conditioning systems used natural refrige...
Study on Flow Boiling of Refrigerants in Micro/Mini-Channels
Study on Flow Boiling of Refrigerants in Micro/Mini-Channels
Abstract
The flow boiling heat transfer in micro/mini-channels is encountered in many compact heat exchangers such as the once-through steam generator in nuclear rea...
Stability Parameter for Two-Phase Vertical Annular Flow
Stability Parameter for Two-Phase Vertical Annular Flow
Abstract
A good theory of stability is essential to the prediction of flow pattern transition; therefore, it is crucial to the design of two-phase flow systems, s...
Pressure Analysis of DST Flow Period Or Slug Flow For Horizontal Wells In Homogeneous Reservoir
Pressure Analysis of DST Flow Period Or Slug Flow For Horizontal Wells In Homogeneous Reservoir
Abstract
By the transient pressure for horizontal well with constant flow rate and Duhamel's principle, this paper presents the method to calculate the transient ...
Determinants of Cerebrovascular Reserve in Patients with Significant Carotid Stenosis
Determinants of Cerebrovascular Reserve in Patients with Significant Carotid Stenosis
AbstractIntroductionIn patients with 70% to 99% diameter carotid artery stenosis cerebral blood flow reserve may be protective of future ischemic cerebral events. Reserve cerebral ...

