Study of frictional wear and desorption of nanoparticle‐rubber blend modified UHMWPE composites

AbstractTo address the issues of abrasive wear, impact wear, and soil adhesion that can lead to wear failure and excessive operational resistance in agricultural soil touching parts during farming. This study focuses on UHMWPE composites, modified by filling Nano‐SiC as a hard phase filler and XNBR as an elastic filler. These fillers were dispersed into the UHMWPE matrix through melt blending technology to create a high‐performance composite material for the surface protective material of soil touching parts. The study discovered that by adding hard and elastic fillers to the UHMWPE matrix, the density, hardness, flexural modulus and thermal stability of the materials were all increased. Specifically, the density increased by 5.67% and the flexural modulus increased by 107%. In the block on ring wear test the volumetric wear rate decreased by 98%, while in the mortar wear test the mass wear rate decreased by 64.64%. Additionally, the contact angle on the surface of the specimen after mortar erosion and wear increased to 102.76°, 18% higher than that of pure UHMWPE. These results demonstrate that the modified fillers can improve the abrasion and plastic deformation resistance and hydrophobic desorption of UHMWPE. UHMWPE composite material, serving as the surface protection for soil touching parts, resolves the issues of abrasion of soil abrasive particles and excessive soil adhesion resistance on these parts. This significantly prolongs the service life of soil touching parts of agricultural machinery and improves the operational efficiency and economy.Highlights Research on nanoparticles and elastomer‐modified composite materials. Research has shown the enhancement of UHMWPE composite materials by Nano‐SiC. XNBR improves the plastic deformation resistance of UHMWPE composites. Effects of Nano‐SiC and XNBR on the desorption behavior of composite materials. UHMWPE composites reduce soil contact wear and soil adhesion.